It is now:

FLEX-PRO Armor Panels

Our Most Cost Effective Armor!!

Return to Vehicle Armor Page

Kevlar | Flex-Pro | Spectra Shield | Dyneema | Steel Armor Plate

FLEX-PRO 50"x41"Thermoformable Vehicle Armor Panels are a laminated composite armor fabricated from a vulcanized urethane 3000 denier aramid composite. FLEX-PRO Armor panels are semi-rigid, and have excellent multi-hit capabilities and will not bunch up or fall down during ballistic incidents or severe vehicle use. Flex-Pro Ballistic Panels are thermoformable, with the use of a heat gun these panels can be formed and bent into complex shapes and will retain these shapes when heat formed.

Further, FLEX-PRO Armor can be cold bonded to the vehicle surface or mechanically attached. Because FLEX-PRO Armor is based on aramid fibers there is no degradation due to vehicle temperature extremes. FLEX-PRO Armor can be easily fit into tight spaces in one piece, thereby eliminating the problems with butt joints, overlaps and the potential of secondary projectiles from the fasteners used to hold the panels in place. At NIJ standard 0108.01 level IIIA configuration of this material has an aerial density of 1.0 pounds per square foot. This provides a significant reduction in weight from more commonly used high hard steel at 6.4 lbs per sq.ft. or aluminum alloy at 3.6 lbs per sq.ft. Please Note: FLEX-PRO Armor Panels will not stop rifle rounds. Please see our Dyneema or Spectra Shield Armor Panels for Assault Rifle Protection.

Our Flex-Pro Armor Panels are readily cut and fabricated using commonly available tools [ a saber saw with a knife blade will easily cut the panels] the cut panels can then be installed in a vehicle using glue, rivets, screws, or nuts & bolts with washers. Butt joints are ballistically weak, reinforce them with a min. 4" wide strip of the same level of armor to cover any gaps in the panels. We can also water jet cut these Armor Panels to your exact specifications, Please contact us for more information.

Our FLEX-PRO Armor panels panels were tested behind .040 aluminum panels, go to next higher level of protection for stand alone applications. Available in sheets sizes of: 50"x41",50"x48",50"x72"and 50"x96".

Request Pricing

FLEX-PRO Armor Panels: 50" x 41" Thermoformable
Threat	Level of Protection	Thickness	Lbs. per Sq. Ft.
.22, .38 Handguns & lesser threats	N.I.J. IIA	9/64"	0.61 Lbs.
.9mm,, .357 Magnum Handguns & lesser threats	N.I.J. II	5/32""	0.8 Lbs.
.9mm,, .357,& ,.44 Magnum Handguns & lesser threats	N.I.J. IIIA	3/16""	1.0 Lbs.

FLEX-PRO Armor Panels: 50" x 41" Stand Alone Use [Non -Vehicle Use]
Threat	Level of Protection	Thickness	Lbs. per Sq. Ft.
.22, .38 Handguns & lesser threats	N.I.J. IIA	5/32"	1.0 Lbs.
.9mm,, .357 Magnum Handguns & lesser threats	N.I.J. II	3/16"	1.7 Lbs.
.9mm,, .357,& ,.44 Magnum Handguns & lesser threats	N.I.J. IIIA	1/4"	2.0 Lbs.

Request a quotation on Vehicle Armor Panels